[isf-wifidog] Redirect question

[Philippe April]

Glad to hear that!

I think we'll need to run some tests to make sure non-ssl setups work.

Thanks for flagging an issue! Keep on testing.

On Fri, Mar 11, 2005 at 11:25:00AM +0200, Marios Moutzouris wrote:
> Hello Everyone,
> 
> Okay the problem is the SSL. I setup a server with SSL (with 1.1.0_beta3),
> and it works fine.
> 
> Marios
> 
> > -----Original Message-----
> > From: wifidog-bounces at listes.ilesansfil.org [mailto:wifidog-
> > bounces at listes.ilesansfil.org] On Behalf Of Philippe April
> > Sent: Thursday, March 10, 2005 5:26 PM
> > To: WiFiDog Captive Portal
> > Subject: Re: [isf-wifidog] Redirect question
> > 
> > Weird... Unless you didn't "refresh" your configuration to fit with the
> > new 1.1.0_beta3 release, there's no reason why 1.0.2 would work but not
> > 1.1.0_beta3. By refreshing I mean to just use the new config file and
> > adapt your parameters into it.
> > 
> > The new 1.1.0 series has a new configuration syntax at the bottom for
> > firewall rules and such.
> > 
> > Now...
> > 
> > Logging out is achived by disconnecting from the access point. After a
> > configurable timeout value, hadn't seen any traffic since a while
> > WiFiDog will log you out.
> > 
> > We could allow people to log out themselves, but usually people are gone
> > surfing and no wifidog window left for them to click "logout" that would
> > communicate their desire to wifidog. Therefore, wifidog watches and if
> > there's no outgoing traffic from that IP + MAC since a little while, it
> > logs them out.
> > 
> > On Thu, Mar 10, 2005 at 05:09:43PM +0200, Marios Moutzouris wrote:
> > > As I replied with the 1.0.2 it works though I don?t know how to do the
> > > logout procedure.
> > >
> > > I tried the below settings, works fine( i go to ilesansfil auth page).
> > So
> > > either the Hostname doesn?t accept IP addresses or it only works with
> > SSL.
> > >
> > > Marios
> > >
> > > > -----Original Message-----
> > > > From: wifidog-bounces at listes.ilesansfil.org [mailto:wifidog-
> > > > bounces at listes.ilesansfil.org] On Behalf Of Philippe April
> > > > Sent: Thursday, March 10, 2005 3:50 PM
> > > > To: WiFiDog Captive Portal
> > > > Subject: Re: [isf-wifidog] Redirect question
> > > >
> > > > Did you run "firstboot" in failsafe to wipe what you had on your
> > > > partition?
> > > >
> > > > I would like to know more details. Make sure the interfaces in the
> > > > config are right, and then run:
> > > >
> > > > insmod ipt_mac
> > > > wifidog -f -d 9
> > > >
> > > > and forward us the details. If you have that image and that ipkg,
> > > > there's no reason why it wouldn't work.
> > > >
> > > > If you want, point to our authentication server
> > > >
> > > > AuthServer {
> > > >     Hostname auth.ilesansfil.org
> > > >     SSLAvailable yes
> > > >     Path /
> > > > }
> > > >
> > > > That way we'll know if that's causing problem on your end.
> > > >
> > > > On Thu, Mar 10, 2005 at 02:00:47PM +0200, Marios Moutzouris wrote:
> > > > > I installed the bin file. And ran the beta3. No luck.
> > > > >
> > > > > Marios
> > > > >
> > > > > > -----Original Message-----
> > > > > > From: wifidog-bounces at listes.ilesansfil.org [mailto:wifidog-
> > > > > > bounces at listes.ilesansfil.org] On Behalf Of Philippe April
> > > > > > Sent: Wednesday, March 09, 2005 8:57 PM
> > > > > > To: WiFiDog Captive Portal
> > > > > > Subject: Re: [isf-wifidog] Redirect question
> > > > > >
> > > > > > Yeah but if our binaries don't fit (not same versions of iptables,
> > > > etc.)
> > > > > > it won't work well.
> > > > > >
> > > > > > If you want an image for your GS that fits with our packages:
> > > > > >
> > > > > > http://www.philippeapril.com/openwrt/openwrt-gs-code.bin
> > > > > >
> > > > > > Then try the wifidog ipkgs (beta3!)
> > > > > >
> > > > > > On Wed, Mar 09, 2005 at 09:06:25AM -0800, Joe Bowser wrote:
> > > > > > > On Wed, 2005-03-09 at 09:47 -0500, Philippe April wrote:
> > > > > > > > Hmmm. Doesn't say much :)
> > > > > > > >
> > > > > > > > Is it a recent aquisition or have you had it for a little
> > while?
> > > > > > > >
> > > > > > > > On Wed, Mar 09, 2005 at 03:41:39PM +0200, Marios Moutzouris
> > wrote:
> > > > > > > > > Thanks.
> > > > > > > > >
> > > > > > > > > It says "Model No WRT54GS"
> > > > > > > > >
> > > > > > >
> > > > > > > This is clearly a 1.0 unit.  All original 1.0 units do not have
> > a
> > > > > > > version number.  Basically, if you're using a GS, you should
> > > > probably
> > > > > > > make sure that you have the proper firmware corresponding to
> > > > WiFiDog.
> > > > > > >
> > > > > > > <shameless plug>
> > > > > > > I recommend going to http://www.infil00p.org/openwrt/snapshots/
> > and
> > > > > > > getting the relevant files to your version of the router (in
> > your
> > > > case,
> > > > > > > pick the v2.0 directory, since that contains the G, GS and TRX
> > files
> > > > for
> > > > > > > an OpenWRT distro, and the corresponding WiFiDog ipk.
> > > > > > >
> > > > > > > There's also a v2.2 directory for v2.2 hardware, which may or
> > may
> > > > not
> > > > > > > work with the WRT54GS v1.1 but I have yet to pick one up to test
> > it
> > > > > > > yet.
> > > > > > > </shameless plug>
> > > > > > >
> > > > > > > There's also other files there of interest, namely just the
> > patches
> > > > that
> > > > > > > I already posted here, and on the OpenWRT forums. :)
> > > > > > >
> > > > > > > --
> > > > > > > Joe Bowser
> > > > > > > e-mail: bowserj at unbc dot ca
> > > > > > > website: http://www.infil00p.org/
> > > > > > >
> > > > > >
> > > > > > > _______________________________________________
> > > > > > > WiFiDog mailing list
> > > > > > > WiFiDog at listes.ilesansfil.org
> > > > > > > http://listes.ilesansfil.org/cgi-bin/mailman/listinfo/wifidog
> > > > > >
> > > > > > --
> > > > > > Philippe April
> > > > > > GnuPG: http://key.philippeapril.com/
> > > > > > Skype ID: mousetrap
> > > > >
> > > >
> > > > > _______________________________________________
> > > > > WiFiDog mailing list
> > > > > WiFiDog at listes.ilesansfil.org
> > > > > http://listes.ilesansfil.org/cgi-bin/mailman/listinfo/wifidog
> > > >
> > > > --
> > > > Philippe April
> > > > GnuPG: http://key.philippeapril.com/
> > > > Skype ID: mousetrap
> > > >
> > > > --
> > > > Internal Virus Database is out-of-date.
> > > > Checked by AVG Anti-Virus.
> > > > Version: 7.0.308 / Virus Database: 266.5.7 - Release Date: 1/3/2005
> > > >
> > > >
> > >
> > > --
> > > Internal Virus Database is out-of-date.
> > > Checked by AVG Anti-Virus.
> > > Version: 7.0.308 / Virus Database: 266.5.7 - Release Date: 1/3/2005
> > >
> > >
> > 
> > > _______________________________________________
> > > WiFiDog mailing list
> > > WiFiDog at listes.ilesansfil.org
> > > http://listes.ilesansfil.org/cgi-bin/mailman/listinfo/wifidog
> > 
> > --
> > Philippe April
> > GnuPG: http://key.philippeapril.com/
> > Skype ID: mousetrap
> > 
> > --
> > Internal Virus Database is out-of-date.
> > Checked by AVG Anti-Virus.
> > Version: 7.0.308 / Virus Database: 266.5.7 - Release Date: 1/3/2005
> > 
> > 
> 
> -- 
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.7.1 - Release Date: 9/3/2005
>  
> 

> _______________________________________________
> WiFiDog mailing list
> WiFiDog at listes.ilesansfil.org
> http://listes.ilesansfil.org/cgi-bin/mailman/listinfo/wifidog

-- 
Philippe April
GnuPG: http://key.philippeapril.com/
Skype ID: mousetrap